Comments by "Mikko Rantalainen" (@MikkoRantalainen) on "" video.

  1. Jake should probably read about basic electronics like voltage dividers or something similar. I guess you could have used some adjustable resistors to calibrate the pedals instead of cutting pieces off. In addition, you could have probably calibrated / programmed the transmitter, too. Unless you have really crappy transmitter it should support adjusting the curve from the controller to the actual behavior. That would include reversing the direction so you wouldn't have needed to swap the pedals. I'm pretty sure that the original 10K pot would have been just fine, too. And if you want even lower latency for the head mounted display, go with full analog setup with rapidFIRE. It will have worse image quality and maximum transmit distance is slightly less but the latency is even better. I'd suggest to try contacting Joshua Bardwell if you need more info about sending video stream over video link with low latency.
    1