Comments by "MARK LOCKWOOD" (@MARKLOCKWOOD2012) on "NoNonsenseKnowHow" channel.

  1. Bunks,re carpet them least paint the motor call it a rat boat?/
    2
  2. bilge pump pour about a gallon see if it sucks it up if not new pump. check by lifting the float on the pump
    1
  3. old school prime the engine through the throttle hit the bottom button to take it out of gear pump several crack the throttle let her idle a bunch. if it will idle bring back to idle click the shifter lever. check forward neutral reverse take back out of gear rev up extra 500 rpms see if temp gauge works. all fluids needs changed store re drain the block. air filter can be rinsed in some gas. yes carb cleaned best to store with full tank best to un hook the battery when not in use can add battery charger 🔌 after sitting during storage. leave the out drive down any excess water drains ready to go every spring. dash lights up grease the out drive . but with milky gear oil usually tell tell seals gone. for travel get arm blocks least what we used takes the weight of the transom check the prop nut i want to see her get ship shape.
    1
  4. Alright why does our evinrude e-etc 150 ho doesn’t like past three grand and the heat alarm 🚨 goes off. This is been going on from brand new then at times you can run it like a scalded dog. Water pump works. Took it back found nothing not issue as a free bee under warranty then they replaced the pump water pressure normal?
    1
  5. forgot a bilge blower we ran ours any idling we did trailering boat docks just to be safe from fumes.
    1