Comments by "drescherjm" (@drescherjm) on "Project Farm" channel.

  1. I have used several Zicom units hundreds of times in the past however I am watching the video because I am not always happy with the detection accuracy.
    2
  2. Mine digital thermostat complains and tells me to call for service but it's just counting days. I think its set for 6 months but I have a 4 inch thick filter. Thankfully I am not locked out of resetting the state and can put in my own darn filter.
    1
  3. Thanks for testing this! Since I already have a charger and batteries for both Dewalt and Ryobi if I would need another hammer drill I would purchase the Dewalt drill instead of the Ryobi kit.
    1
  4. This is good timing for me. As I cyclist I have multiple inflators which I know are inaccurate. One reads about 7psi high and the other reads low. I want to get a digital one gauge that is small and accurate.
    1
  5.  @ProjectFarm  After watching the video, I lean towards SKS Germany because it has presta but the ETENWOLF looks like a great value. Presta is not essential as I always have an adapter since my inflators are schrader. Edit: I got the ETENWOLF Plus with presta adapter.
    1
  6. For a while I switched to more expensive modern beam style blades but then had tearing issues that seemed to be related to too much contact pressure so I switched back to the cheaper blades and replace them a week before I go for my annual state inspection. So I don't have to pay the shop 3 times the cost of the blades they install.
    1
  7. 0:50 Oh my, please don't put the word fire in the name of a lithium battery!
    1
  8. About a month ago I purchased the Ryobi to replace my corded Arrow. Since then I have used the Ryobi about a dozen times mainly for Inline Skate repair and modifications to the boot lacing to add an additional loop for the laces at the top. It has worked wonderfully for all my usage and it is much easier to use without the cord. The arrow with the cord was very cord heavy causing it to easily fall all the time especially when used on a small table. With the Ryobi its very stable with the battery side down. I haven't knocked it over yet.
    1
  9. I was just thinking of this today since my headlights on my 2011 Tucson are just beginning to show a little oxidation.
    1
  10. I have 2 of the same nocos which have worked well for me using on mid sized SUV or smaller. However if these break I will remember this review..
    1
  11. If you are talking about fuel cell cars the hydrogen has to be highly compressed some as much as 10000 PSI /700 bar. This is not practical from this device.
    1
  12. I am watching this again because my Ryobi P737D has died in about 3 years. It had been sounding very bad for a long time but still worked. Today I tried to inflate my suv tires and it couldn't get to 30psi. I use it both for my 2 suvs and 2 bicycles. I need a replacement about the same size as the ryobi (so I can take it with me on cycling trips) that will last longer.
    1