Comments by "Clarence Wiles" (@clarencewiles963) on "" video.

  1. Thumbs up 👍 take the hose off the equipment, leaving the hose on the cylinder to extend to the bucket 🪣 you may need to add a extension hose Under the seals I would use STP, or the system oil underneath the O ring or seals to pre Lube not much needed just wet. Before you install check the cylinder for any sharp edges and or rounding over so it doesn’t cut the O ring or seals a slightly rounded edge. Or use a thin plastic sheet that you can pull out. And yes on a new control valve. One speck of sand can wipe out the entire system.
    1