Comments by "" (@Alberthoward3right9up) on "Project Farm" channel.

  1. The old boys used to put a handfull of Ajax powder down Datsun carburettors to de-glaze the bore. They used to swear by it
    2
  2. I was going to suggest the same thing but I Think he wanted to clean the back side of the throttle plate too. And the way he did it is the only way. Lucky it didn't have coolant lines lol..
    1
  3. I have frost drill bits. Was hoping they would make an appearance. Still a good job tho as usual
    1
  4. It would be interesting to see if the STP one would last as long with double the additive. Wynn's Australia do good additives
    1
  5. Shouldnt of watched this. I own three of the tools listed..
    1
  6. The weak link is the cast iron inserts in the cheaper stands. I had one crack in half and when I checked it out it had an Air bubble in the cast iron..was a good quality stand too. I only use the ones with holes drilled in steel box section
    1
  7.  @ProjectFarm  bit late now but it would of been interesting to see if where yours broke had bubbles too.
    1
  8. Something to point out. Check out how high your jack lifts. (Or doesn't) before purchasing..The average jack won't get high enough to go to the top level on most stands. And small jacks won't lift a car high enough to get a stand underneath.
    1
  9. That farmabeggo sounds awesome. Love the big arsed side pipes
    1
  10. I'd be interested to see how many batteries you need to cut a trailer full of wood. Let alone a day cutting wood. Wouldnt be pretty I don't think.
    1
  11. I would be getting some carburettor cleaner and cleaning that throttle body. That's still nasty. Be nice to know how it went after the tank full of juice went thru it too.
    1
  12. I've watched 100s of your videos and never done this. But the dial indicator test for shaft slop was ineffective. The handle was moving up and down on the Milwaukee and a few other drivers I noticed.
    1
  13. @Hand Tool Reviews he usually replies to all my comments. Not this one tho
    1
  14. Set of plugs and a fuel filter and Bo's your auntie
    1
  15. Are any of these comparable with kingchrome ?
    1
  16. And the snap on snapped off. 😂😂
    1
  17. I'd wait until he tests the heavy duty ones..cheaper Heavy duty ones will perform better than some of these.
    1
  18. I have a different pair of millwakee ones that were expensive. They work awesome
    1
  19. We have a product in Australia called Wynn's friction modifier or something like that that is supposed to do the same thing
    1
  20. The Pittsburgh weighs a little more because of the extra welds 😂
    1