Comments by "Burnt Kitty Forge" (@BurntKittyForge-pl8ol) on "I built a FLAP ENGINE (New Rotary Design)" video.

  1. I enjoy all your videos , I like the one turbine that was moving around 6000rpm because it's within the operating range of an automotive alternator without gearing ....I'll search for it again , cool that it could be 3d printed iirc...thanks
    1
  2. ..another make it better idea as suggested is similar to one of Robert Murray Smith's wind turbines , he liked three blades and two so one was on front and the other on the back , it maximized the air flow by using the same wind on two and he explained the three blade balanced better than two iirc...
    1
  3. ok , my idea to make it better is to add one or more maybe a few smaller propellors and [edit: motor(s))] decreasing in size from the main motor so those use the exhaust to push smaller motor and propellor(s) until it is diminished output returns....
    1
  4. I commented to Tom Stanton on his air drag car it could maybe use a clutch and flywheel so it can get up it's speed before the start launch , there are basically cable or hydraulic clutch , activated or centrifugal clutch , I had fun a few days pondering clutch applications , for example a centrifugal clutch can go on each pulley as well for a transmission , a cable clutch can be normally engaged and switched off to engage other drives, a centrifugal or cable clutch can allow proper speed or a pause in the action entirely or activate a hammer motion even and more...
    1