Comments by "chru cas" (@Chr.U.Cas2216) on "DIY Flatbed Build [part 1]" video.

  1. Dear Mr. Waldo. 👍👌👏 Very "weld" done again (video and work). I'm eagerly looking forward to watch the next part. 2) I saw you using a tape measure. Therefore please kindly allow me to suggest something about a totally common but wrong behaviour (I did wrong too until I learned the hard way = I'm always good as it bad example): Please try to avoid letting slip/flip the scale tape back against the tape measure cover because this behavior will lengthen/harm it. Sooner or later this habit will cause faults in measurement from at least 1mm up to 3mm! Additionally: A lot of tape measures have a kind of loose respectively movable angled stopper on purpose. It's for balancing the little but important difference between measurements with a tape that is hooked onto something in relation to a tape that is pushed against something. Let it flip and the angled stopper will become more loose than it's supposed to be and/or become crooked. In this case it will never hold on an edge while measuring (worst case = it will brake away). And of course it will not measure correctly any more. 3) Thanks a lot for making teaching explaining recording editing uploading and sharing. Best regards luck and especially health to all involved life forms (human and dog). 😁 ;-)
    1
  2. Dear Mr. Waldo. In Germany 3 types of circuit breakers (A, B and C) are existing respectively available (most people don't know that). Maybe it's the same in North America and you simply need (respectively should have) the ones that react the slowest when you have a workshop. Best regards, luck and health in particular.
    1