Comments by "Cory Driver" (@corydriver7634) on "SuperfastMatt" channel.

  1. Oh man now ai need a label maker that prints on heat shrink tube. When you were discussing fuse size I was confused when you said “if you’re not sure about fuse size, err on the side of too much fuse”. Seems counter intuitive, wouldn’t you want not enough fuse so it would break the connection before something burned up?
    1
  2. To get that badge off that Extreme Toolbox, try warming the inside of the drawer slowly with a heat gun on low. Also Goof Off or Goo Gone will help get the sticky stuff off. New subscriber Love the channel so far.
    1